Grips are consumables. They wear out unexpectedly. You can replace the grips when they wear out, but the cost of a grip heater, an OEM product of a European car, is high. Therefore, Heat Shrink Tubes are used to protect them from wear.
For fishing rods. However, I am using this product, which is a Motorcycle product, because I am concerned about the appearance of the product.
To install, simply heat it up with a commercially available heat gun. The overall length is 105mm and fits snugly without cutting.
It may depend on the Gloves, but with the Gloves I use, I don't notice any slippage.
The grips are thicker, so people with small hands may feel some discomfort.
- Instock
26.69 MYR (934 JPY)
Webike Point: +9 pt
(0.25 MYR)
Delivery Information
In Stock : 2 left, Ships within 24 hours.
Estimated arrival date around
Product detail
[Color] Black
[Size]
・Tube inner diameter: Φ40
・Total length: 105mm (before shrinkage)
[Quantity] For 1 vehicle (2 pieces)
**A heat gun is required for installation.
*The overall length of the product has a tolerance of plus or minus 3 mm due to its characteristics.
*The edge of the product may be slightly slanted, but this is not a defect.
*When used for grip heater, the tube may be softened by heat and loosen.
.
Shrink tubing to help prevent wear on the grips.
The surface is designed to be non-slip and safe.
It is the best product for expensive grip heater.
Points of Attention
* If there may be an instruction manual included, it will be written in Japanese.
NEW ARRIVALS IN USED PARTS FOR
NEW ARRIVALS IN USED PARTS FOR
NEW ARRIVALS IN USED PARTS FOR
New arrivals in used
New arrivals in used
Customer Reviews
Reviews with image
Jul 7, 2022
Helpful?
Dec 18, 2021
It's a very ordinary Heat Shrink Tube.
Used to fix a wrap-around Grip heater.
I used to use a common Heat Shrink TubeTube that is also sold at Home center, but I was a little concerned because it was slippery or compatible with Glove.
It's in the product description.
The surface is designed to be non-slip and secure.
I bought this book because I was attracted by a sentence that says
In conclusion, it is the same with Large. Rough operation, if you are not careful, it will slip.
If you don't care about the manufacturer or the pattern, Recommendation is not for you.
I bought a cheap heat gun from Amazon for installation. (It's not that hot) I worked with it, but this product was easier to shrink and I had the impression that it was less loose when I heated it up again using the Grip heater.
Overall, I don't recommend it, but I think it can differentiate itself from other users who use Heat Shrink Tube. The price is a little bit high.
Helpful?
New Custom Articles
