[Specification] ・Rated voltage: DC12V ・Outer diameter dimension: W25.5mm x H30.5mm x D15.5mm (*excluding protruding parts)
[Components] ・SPI-110 C1 main unit x 1 ・Model Specific Harness x 1 ・Various double-sided tapes ・Instruction manual *Components vary by kit.
*When the clutch is depressed while driving, the display shows a gear other than the one in which the clutch is engaged, but this is not a malfunction. *Prioritize safety while driving and do not be careless in front.
*Please do not use non-resistive spark plugs.If you use a plug without resistance, noise may be generated and the rotation signal may not be input correctly, so please use a spark plug with resistance. *Please put the attached double-sided tape on the back side of this product to prevent water from entering because there is a switch. *Install the product correctly according to the instruction manual.Improper installation may result in fire or equipment damage. *After installing this product, periodically inspect it to see if any parts have fallen off. *PROTEC is not responsible for any damage or accident caused by the use of this product. *Protec is not responsible for any labor charges for removal or other expenses incurred during repair. *All vehicles that have been tested by Protec are stock.There is a possibility that a problem may occur if the vehicle is equipped with aftermarket parts other than stock parts. *Please refer to the service manual of your motorcycle to confirm the respective wiring before installation.
●All the necessary parts are included in this kit!Easy installation with special harness! It can be installed easily without soldering because it uses a special harness for each model. *The vehicle-specific harness has a 12V (+) service terminal for easy installation of the CS-550 burglar alarm.
●Compact design! The main unit dimensions are W25.5mm X H30.5mm X D15.5mm (excluding protruding parts), a compact design that does not interfere with installation around the meter.
●LED display for high visibility! Equipped with a dimmer sensor [automatic dimming function].The brightness of the LED is automatically adjusted to be brighter in the daytime and darker at night to improve the visibility of the digital numerals.
●Equipped with a shift up indicator! Since the rpm can be set arbitrarily, it can be used for everything from narrowing to preventing over-revving.The blue LED will light up when the rotation is higher than the set value. *You can re-register as many times as you like.
Points of Attention
* If there may be an instruction manual included, it will be written in Japanese.
Because the engine speed of the NC 700X is low, I thought that I wanted the shift position from a long time ago. (The latest type will appear in the meter so it will not be a problem, but crying) In the instruction manual, it is stated that the designated circuit is branched from the vicinity of the engine control unit, but if I did not like to branch at the coupler, I thought that it was difficult to install the branch coupler, so the manual (Separately obtained) When checking the circuit, I was able to confirm that I got the ignition timing of No. 2, so I unplug the plug and branch off the insertion signal again. (I removed parts that will accommodate the user box helmet, but it may be possible to branch just by removing the left side cover) In order to install the display Unit, you will remove the Connector on the back of the Speed ??meter, so those who care about Waterproof may feel uneasy with the Cover included. The Reverse side of MeterBox (It becomes the back of the draft shield) I think that I can not expect a stylish fit because a lot of Cable etc is entered. However, I am extremely satisfied with the display of Shift position.View Detail
NC700 of low rotation had the incomprehensible check of the Shift, and it purchased it.Although it was the elegance only for NC, the error occurred frequently and it carried out the re set at the beginning of .Now, the general-purpose article could be sufficient. The circumference of it and the Coupler to a Meter is made in a jumble, is, and there is then. [ no ]Also in , it is good that the check of a Shift position can be performed.View Detail
[Webike Monitor] It is very convenient.Moreover, there was a Service terminal of 12V, the Navigation which was turning on the Switch manually till then was connected, and there was also an addition of becoming key linkage.It is a little sorry that the circumference of a Meter is confused to be the relation which put the exclusive Harness into the terminal linked to a Meter.Attachment is OK if a description is seen, but parts to be removed by the screw thread are insufficient.I think that correction is required.View Detail
* The BEST and MUST store to find Japanese parts. * Register now for amazing deals and other special offers! *Over 800,000 listed items. It's hard NOT to find your parts.
SIGN IN TO WEBIKE JAPAN
Please enter email at least 6 characters.
Please enter a valid email address.
Email is already in use.
Your account has been banned.
Email address and/or password is not match.
Authentication with facebook fail.Please try again.
Please select How did you get to know about Webike Japan?
OR
YOUR ACCOUNT HAS BEEN CREATED!
Congratulations! Your new account has been successfully created! You can now take advantage of member privileges to enhance your online
shopping experience with us. If you have ANY questions about the
operation of this online shop, please email Webike through CONTACT US.
A confirmation has been sent to the provided email address. If you
have not received it within the hour, please contact us.
Get on your grid by register your motorcycle! About our "Mybike" service
"Easier to Search Items" It helps you to search items to fit for your motorcycle!
"Get Much Valuable Information" It helps you to get special deals, newly listed items and closeouts about your motorcycle!
"Easy to Register" It requires only your motorcycle manufacturer, model name and model year!